P5g41t-m lx2/gb/lpt front panel audio connector, P5g41t-m lx2/gb/lpt chassis intrusion connector, Aafp – Asus P5G41T-M LX2 User Manual.Page 23: Chassis. Chapter 1: Product introduction. Front panel audio connector (10-1 pin AAFP) This connector is for a chassis-mounted front panel audio I/O module that supports. either HD Audio or legacy AC`97 audio standard. Connect one end of the front panel. audio I/O module cable to this connector. P5G41T-M LX2/GB/LPT Front panel audio connector. • We recommend that you connect a high-definition front panel audio module to this. connector to avail of the motherboard’s high-definition audio capability. • If you want to connect a high-definition front panel audio module to this connector, set. the Front Panel Type item in the BIOS setup to [HD Audio]. If you want to connect an. AC'97 front panel audio module to this connector, set the item to [AC97] . By default, this. connector is set to [HD Audio] . See section 2.4.2 Chipset for details. Chassis intrusion connector (4-1 pin CHASSIS) This connector is for a chassis-mounted intrusion detection sensor or switch. Connect. one end of the chassis intrusion sensor or switch cable to this connector. The chassis. intrusion sensor or switch sends a high-level signal to this connector when a chassis. component is removed or replaced. The signal is then generated as a chassis intrusion. By default, the pins labeled “Chassis Signal” and “GND” are shorted with a jumper cap. Remove the jumper caps only when you intend to use the chassis intrusion detection. P5G41T-M LX2/GB/LPT Chassis intrusion connector. The Chassis intrusion connector is an optional item for P5G41T-M LX2 and. Ссылки на скачивание:
 |